Ari's 2016 Study Guide For DAT Domination: Preface
Ari's 2016 Study Guide For DAT Domination: Preface
Volumes 4 and 5 of the DAT Newsletters were the ones referring to changes in the
biology and quantitative reasoning sections. Therefore, please do not neglect
trigonometry, geometry, etc. because you heard the DAT was changing. All these
subjects are still important for you to know to do well on the test. Note its still
possible the test will change going forward, but at least we know its remaining the
same for now. My recommendation is to study how we always have, and that is the
path to the highest scores. If you continue to work hard and study, you will do well,
and that will always be true.
Finally, 3 quick tips as you prepare for the DAT:
1. Create a study schedule that goes over what you need to do day-by-day and stick
to it. Readjust the study schedule if necessary.
2. Take regular breaks. Try to study for 50 minutes and then take a break for 10
minutes. Take one day off a week to relax so you dont burn out.
3. If you dont feel ready to take the DAT, reschedule the test for later. It was the
best decision I made while studying.
To your success,
Ari
www.datbootcamp.com 2016
Introduction
So, you want to dominate the DAT? This guide is a combination
of everything I have learned about test taking, the best study
materials, and the DAT itself. Im Ari, founder of DAT Bootcamp,
and in this guide I will outline a study plan that has worked for
myself and many other people. Im going to go through some
general DAT advice, the recommended materials to use, and a
breakdown on how to tackle each section on the DAT.
Before we get started, its important to note there are many ways to ace the
DAT. This is just one way thats been used by many students. Some students
only study 1-2 weeks and ace the DAT, others like myself take up to 3 months. Some
students only use their college textbooks and notes while others buy review guides.
It all depends on how good of a foundation you have in the basic sciences, along
with your test taking skills and endurance. You can personalize this study guide to
reflect your strengths and weaknesses.
www.datbootcamp.com 2016
www.datbootcamp.com 2016
www.datbootcamp.com 2016
www.datbootcamp.com 2016
Biology:
Use either of the following two books. Having both books is not necessary:
o Cliffs AP Biology 3rd Edition (Free here). Ive heard mixed reviews
about the 4th edition and only recommend the 3rd edition for now.
o Barrons AP Biology (lots of good reviews too, I havent personally
used it).
DAT Destroyer
Khan Academy: Set of free videos to clearly explain any concept in either of
the chemistries.
o http://www.khanacademy.org/science/chemistry
o https://www.khanacademy.org/science/organic-chemistry
www.datbootcamp.com 2016
PAT Trainer Game: Play this game to enhance your perceptual ability. This is
some of the best practice you can get, and its free:
http://datbootcamp.com/classroom/perceptual-ability/pat-trainer-game/
Reading Comprehension:
Math Destroyer
www.CourseSaver.com
www.datbootcamp.com 2016
www.datbootcamp.com 2016
Section Breakdown
The DAT consists of 4 sections: Survey of Natural Sciences, Perceptual Ability,
Reading Comprehension, and Quantitative Reasoning.
Biology
The biology section is probably the toughest to prepare for because of the breadth
of the material. For this section, we are going to read and memorize all of AP
CliffsNotes Biology (except the lab information in the back) and take a lot of notes.
DAT Destroyer is good for learning a lot of little facts as well. DAT Bootcamp will tie
everything together and get you ready for the real DAT.
An SDN member uploaded their comprehensive biology notes to our website which
covers nearly everything under the sun. I highly recommend giving this a read
through after youre done reviewing the AP biology book:
http://datbootcamp.com/feralis-biology-notes/
However, the best way to prepare for the biology section on the DAT is to
create your own set of notes. Its good to review these notes if you need to look
up something in particular, but youll see significantly better results if you take the
time to make your own notes. Its relatively simple, just make a two-column table in
Microsoft Word and write the topic in the left column, and all the details in the other
column. Draw your own diagrams on paper if you need to (helpful for learning how
photosynthesis and respiration work, for example). You can also make flashcards
from your notes and review for a little bit of time wherever you are (highly
recommended). However, DO NOT copy and paste things into your notes, you have
to write your notes in your own words for this to be effective.
www.datbootcamp.com 2016
Perceptual Ability
Unless youre in architecture or engineering, its likely you have never encountered
this material before. You have 60 minutes to complete 90 questions that test your
spatial and perceptual abilities. The 90 questions are broken up into 6 sub-sections,
including: keyholes, top-front-end, angle ranking, hole punching, cube counting, and
pattern folding (in that order).
The good news is that anyone can learn how to beat this section. Itll be frustrating
at first, but if you stick with it and carefully review the solutions, youll begin to know
what to look for. Well be using DAT Bootcamp PAT practice tests and solutions.
www.datbootcamp.com 2016
10
Keyholes
View the official instructions to the PAT on the ADAs website.
Watch this video on the keyhole section
Keyhole instructions: Page 24
A 3D object is presented and you have to determine which aperture it will
perfectly fit through, like a key in a lock.
Always start by looking at the answer choices and try to match them up to
the 3D object. Use the process of elimination, look for which answer choices
will NOT work and eliminate them. Often these questions will be proportionbased, so you will have to judge distances and slopes.
Top-Front-End
View the official instructions to the PAT on the ADAs website.
TFE instructions: Page 28
Two 2D images of a 3D shape are provided and you are asked for the third
2D image. A solid line is a change in elevation that you can see; a dotted line
is a change in elevation you cannot see. Check out this tutorial for an indepth explanation:
DAT Bootcamp TFE Tutorial
Tackle these problems by focusing in on one single piece of the image in the
two given views. You should focus on any walls or unique looking pieces of
the image. Using that information, try to determine which of the answer
choices matches up correctly to that area. Eliminate answers that do not
properly match. If you cannot eliminate any answer choices, choose a
different piece to focus on and see if you can eliminate answers. Rinse and
repeat until you have the correct answer.
Its important you DO NOT use the line counting method when practicing
for this section. Line counting is an old technique that used to work on older
versions of the DAT. However, line counting will eliminate either none or only
one of the answer choices on the updated DAT. You need to be able to
visualize the 3D object.
www.datbootcamp.com 2016
11
Angle Ranking
View the official instructions to the PAT on the ADAs website.
Angle ranking instructions: Page 33
Watch this video on the Angle Ranking section
Start using DAT Bootcamps Angle Ranking Generator to increase your angle
ranking skills.
A set of four angles is presented and you have to rank them from the
smallest angle to the largest angle.
This section is probably the most frustrating to get better at. Play our Angle
Ranking Generator game to keep getting new angles to rank. Try to spend
the least amount of time on this section. You are much more likely to get
other questions correct if you spend more time on them. Spending more
time on an angle ranking question doesnt usually mean youll have a better
chance at answering it correctly.
Hole Punching
View the official instructions to the PAT on the ADAs website.
Hole punching instructions: Page 38
Start using DAT Bootcamps Hole Punching Generator.
A square piece of paper is folded multiple times and hole punched. You must
unfold the paper and determine where the holes lie on the paper.
Draw a 4x4 grid on a piece of paper before you attempt to do these
problems. Then, starting with the last fold, unfold the paper one step at a
time. Anytime you see a hole punch in the paper, mark where it is located on
the 4x4 grid. Continue to unfold the paper one step at a time until you have
your solution on the grid, then match it up with one of the answer choices.
Watch this video on the line of symmetry (LOS) method for the hole punching
section
www.datbootcamp.com 2016
12
Cube Counting
View the official instructions to the PAT on the ADAs website.
Cube counting instructions: Page 43
Watch this video to learn how to beat the cube counting section
Start using DAT Bootcamps Cube Counting Generator.
A set of ~15 cubes are presented and you must determine how many cubes
have x amount of sides exposed. Usually one figure is presented for 3
questions.
To tackle these problems, make a 2-column chart shown below:
# Sides Exposed
# of Cubes
0
1
2
3
4
5
Then, go one-by-one to each cube and determine how many sides each cube
has exposed. Make a tally each time you count the number of sides a cube
has exposed on the right. The bottom of a cube is never counted as an
exposed side. In addition, there are no floating cubes; every cube must be
supported by another cube underneath them.
www.datbootcamp.com 2016
13
Pattern Folding
View the official instructions to the PAT on the ADAs website.
Pattern folding instructions: Page 48
Watch this video to learn how to beat the pattern folding section
Start using DAT Bootcamps Pattern Folding Generator.
A flat 2D image is shown and you have to fold the image into a 3D shape. Its
important to note that you have to fold the image INTO the plane of the
paper, NOT up and out of the plane of the paper. Again, the trick here is to
focus on just one aspect of the shape. Try to match one of the shapes in the
answer choices to the image in the question. Then, determine which piece
would be connected to that piece. Dont try to fold the entire image in your
head, just focus on figuring out the orientation of 2 pieces at a time and
eliminate answer choices that dont work.
Reading Comprehension
Youll be presented with three ~1500 word scientific passages with 16-17 questions
per passage. Youll have a total of 50 questions and 60 minutes to complete this
section.
Reading is a tough section to prepare for, and its best to prepare for this section
over a long period of time. The good news is that if you are able to read this study
schedule, you already have the skills to pass this section. Well be using DAT
Bootcamp RC practice tests and outside articles.
The reading on the DAT is different from the SAT/ACT. It focuses more on detailbased questions rather than conceptual/application questions. Often, the question
will refer to a specific part of the passage, and the answer can be read directly from
the passage without any comprehension. Its more of a text-based scavenger hunt
than a reading comprehension test.
Everyday, navigate to our reading comprehension classroom page
(www.datbootcamp.com/classroom/reading-comprehension) and pick out an article
or two to read from Scientific American. The best way to improve your reading is by
reading similar content that will be found on the exam. It doesnt take that long to
read these passages. Try reading them before class gets started, while you wait in
line at Starbucks, or even as youre eating lunch.
www.datbootcamp.com 2016
14
There are a lot of strategies to tackle reading comprehension. Youll have to practice
and find out what works for you. For me, I read the entire passage and then answer
the questions, very plain and simple. It worked best for me, but you may find
another strategy works better for you.
Others use a method called search and destroy, where you dont read the passage
and go straight to the questions. This is a true text-based scavenger hunt. Once you
read the question, you quickly scan the passage and look for keywords that the
question refers to. Then you read that specific part of the passage and answer the
question. Questions that require some comprehension are marked and answered
after all of the detail-based questions have been answered, because by then its
likely you read the entire passage. Students have plenty of success with search and
destroy; I didnt like it because it put too much pressure on me when I couldnt find
an answer. Try it out and see if it works for you.
Another method involves writing down all of the paragraph numbers on a sheet of
paper and reading the entire passage. As you read each paragraph, you write a few
keywords that describe the paragraph. For example, you could say 1. Origin of
disease; 2. Mechanisms; 3. Causes; 4. Etc.. This way, you have something to refer to
if you need help finding an answer in the passage. If a question asks Which of the
following describes the mechanism of the disease?, you can refer to your notes and
see that paragraph 2 talks about mechanisms.
Quantitative Reasoning
40 math questions are presented and must be answered in 45 minutes. The
question difficulty goes up to algebra II and trigonometry, no calculus is required.
Youll have an on-screen calculator, however, the calculator may have a slight lag.
We built our calculator in a similar fashion to help prepare you for this. Be sure to
hit Clear plenty of times before you start a new calculation!
Since this is a time-intensive test, we will tackle this section in two runs. First, go
through the exam and answer all of the easy questions. If you see a problem and
you immediately know how to do it, solve it right there. If a problem looks difficult or
youre not sure of how to solve it, guess, mark, and move on. Once you answer all
the easy questions, move on to the marked questions. This way, youll get all the
easy points and at least put down an answer to all the questions.
Well use Math Destroyer and DAT Bootcamp QR. Both of these are tougher than the
real exam, but youll thank us when you breeze through the real DAT QR section.
www.datbootcamp.com 2016
15
www.datbootcamp.com 2016
16