I read that mites can't survive temperatures above 60C, and wondered then about just a big plastic bag around the item then fill it from a hot air source (hair dryer, fan heater)?
I think the problem would be temperature control, as you don't want to damage the item, but need to maintain an even, specific air temperature, you'd need turbulence. Then vacuum clean afterwards.
Maybe a wallpaper remover style device with a hot air source instead of steam??
I guess they just don't want folks giving themselves burns during sleep.
AliExpress as always is tempting [1], but you'd have to be incredibly careful about regulating temperature [2] and adding safety interlocks that'd make falling asleep with it active, or forgetting to turn it off impossible.
Look into something like flexwatt tape. Maybe run it during the day when your not sleeping. In my mind, they probably use something similar inside heated blankets with some kind of limiter/thermostat.
Do your research though!! I'm not sure if flexwatt tape could ignite your mattress, but you would definitely want to know for sure yourself beforehand!
There are ways to control heat though; I'm familiar with using flexwatt tape with reptile enclosures, hooked up to a thermostat with a probe in the habitat for temp control. Maybe some math, like desired_temp = watts_supplied * feet_of_fw_tape, where the watts_supplied is the independent variable you adjust based on the required feet_of_fw_tape for your mattress to get the dependent variable desired_temp. Probably include a fail safe, but I'm no electrician, proceed at your own risk.
They do sell self contained fire extinguishers you can hang on your ceiling that deploy automatically at a certain temperature, ideally putting out fire sources they are hung above. Nice to have around for things like this.
>I read that mites can't survive temperatures above 60C, and wondered then about just a big plastic bag around the item then fill it from a hot air source (hair dryer, fan heater)?
People do something similar to kill bedbugs, I think they make specialized equipment to do so, but it might just be something like an off the shelf heat gun.
I think the problem would be temperature control, as you don't want to damage the item, but need to maintain an even, specific air temperature, you'd need turbulence. Then vacuum clean afterwards.
Maybe a wallpaper remover style device with a hot air source instead of steam??